한국어　|　English　|　中國語
KNDSYSTEM

KNDSYSTEM System+
SYSTEM Material
1. Two Liquid Dispener
▶ Sealant : 1K Epoxy, Rubber, Bond Silicone, UV Resin, Loctite, SuperGlue, Anaerobic Sealant
▶ Molding : 1K Epoxy, 2K Mixing Epoxy, 1K Silicone, 2K Mixing Urethane, Acrylic Acid Resin, Aromatic, Cosmetics
▶ PASTES : Silver Paste, RTV Silicone, Cream Solder, Conductive, Epoxy
▶ OIL: Engine Oil, Silicone, Lubricant
▶ PAINT: Enamel, Water Paint, Oil Paint, Lubricant
▶ CHEMICAL : Alcohol, Acetone, Toluene, MEK, TCE
▶ SEALING :1K Epoxy, 2K Mixing Epoxy, 1K Silicone, 2K Mixing Silicone, 2K Mixing Urethane, Cartridge Silicone
2. Liquid Viscosity
▶ The Viscosity of Liquidity generally express CENTI POISE(as shortly CPS), Standardization 25Degree.
The Measure SSUS is SSU × 1,455 = CPS
3. Liquid Gravities
▶ The Related Value are based on the water, The mixing ratio are determined over 2K mixing Liquid.
4. Time of Double Enlarge Viscosity
▶ Generally, the Change of Viscosity less when 100gram
▶ In other words, based on the ambient temperature 25 ° C means that this work possible time,Additionally to reach time double viscosity, hardening is drastically accelerated In other words, based on the ambient temperature 25 ° C means that this work possible time.
In addition, to reach twice the initial viscosity, hardening is drastically accelerated.
5. The Conditions of Hardening
▶ The way of hardening is divided into three ways. One is Heating Hardening & Automatically Hardening, High Reaction Hardening.In consideration of the characteristics of such a material to the selected discharge unit.
6. 1 Time Exhaustion Volume, Time of Working.
▶ To Set up[ a single discharge and working hours per moreover, Since requirements relating to the discharge capacity,You need to be sure to check it out. r your job specifications you need to be sure to check it out.
◎ Viscosity Conceptions

▶ Liquidity material, first to check from manufacture its character, in case of not sure its character, May consider as follows guide post.


◎ discharge Form